Tektronix 560 user manual Transfer kit, Replacing the Transfer Kit

Caring for Your Printer 6

Transfer kit

Front panel messages

Transfer kit:replace Replace the Transfer Kit (roller/waste bin) soon.

Diagnosing print quality

■Toner spots appear on the back side of the media.

■Repeated light spots.

■Print the Consumables Page from the front panel.

■Check the % Remaining gauge.

■Print the Confi guration Page from the front panel or access the front panel System Counts menu.

■Check the Transfer Kit Count; compare the number to the component’s average life (refer to page 6-3).

Replacing the Transfer Kit

1.Open the printer’s left side door; use the blue handles to pull out the paper feeder.

2.Lift the cover of the paper feeder. Remove the transfer roller/waste bin; place it on a piece of paper on a flat surface.

3.Lock the roller onto the waste bin by placing a piece of paper over the roller and pressing down until it snaps tight; rotate the handles down to lock the roller in place. Dispose of the old Transfer Kit as normal office waste.

4.Take the new Transfer Kit from its packaging and lower it into the paper feeder. Rotate the handles down. Make sure that the roller/waste bin is seated evenly into the opening (otherwise, the paper feeder will not close).

5.Lower the paper feeder cover and press on it to lock it in place.

6.Slide the paper feeder back into the printer and close the printer’s left side door.

7.Reset the copy count on the front panel:

■ The front panel displays this message:

New Transfer Kit?

N o Yes

■Press the Yes button, then press the Confirm button to automatically reset the copy count.

Note If you changed the Transfer Kit before the front panel reported a need to replace it, you will have to reset the copy count manually:

■Press the Menu button to enter the menu.

■Navigate to the Transfer Kit count menu; press Reset; press Confirm.

User Manual 6-9