Teledyne 651 RALL Read Operating Condition

APPENDIX A Firmware Commands Teledyne API Ultrafine Particle Monitor - Model 651
A-4 07506C DCN6727
RALL – Read Operating Condition
RALL reads the Model 651’s operating condition, calibration
parameters, and diagnostic parameters.
RALL
Command RALL
Response X X = a list of operating condition, calibration
parameters, and diagnostic parameters (see
below)
Example
Command RALL Read Analog Input Voltage
Response
Model 651 Ver 1.01 S/N 83031002
ROM Checksum, 356E
Service Date Cal_Reminder Num 0101-30,0101-30,6
On time Las time, 497:10,389:30
Laser SP mA, 750,0
Detect Offset Thrsh HV Photo, 3700,125,1000,0
Ejection Rate, 60
Cap Flow SP Offset Value, 2500,3,5
Nozzle SP Offset Val Flow, 254,128,121,0
ABS Raw Mbar Inlet_Cap, 3267,991,0
Deadtime Corr Val%, 117,84
Inlet SP Temp Drive Cal, 100,221,0,221
Optics SP Temp Drive, 600,509,1023
GT SP Temp Drive, 600,512,1023
Cond SP Temp Drive Zero Current(ma),200,200,103,134,59
Sep SP Temp Drive Zero Current(ma), 200,200,66
Fill Cond_Thresh GT_Thresh, 850,700
Analog Output DAC Span Offset, 217950,1291
Analog Input ADC Span Offset, 9801,100
Cabinet SP Temp(bits) Temp, 1722,1722,25.0
Particle Conc, 0.00
Pulse Height Threshold, 150
Network Setting (DHCP State), STATIC
MAC Address, 0:55:3:4:F3:DA
IP Address, 192.168.20.201
Subnet Mask, 255.255.255.0
Gateway Address, 192.168.20.1