Teledyne API Ultrafine Particle Monitor - Model 651

Unpacking and Setting Up the Model 651

Figure 2-7

Installing Model 651 in a Rack

2. Place the Model 651 in the rack.

W A R N I N G

When mounting the instrument in a rack location be certain that the back panel power on/off switch is accessible or that a readily accessible means of disconnecting power is provided.

Connecting the USB Cable

Connect the provided USB cable to the USB connector on the back panel of the Model 651. If you have placed the monitor in a rack, you can use an extension cord to connect the port at the back of the instrument to the port on the rack-mount handle to give you easy access to the USB port.

Connecting Power and Warming up the Model 651

After you connect the power, the warm-up process takes approximately 20 minutes.

Follow these instructions to connect the power and warm up the

Model 651:

1.Plug the power cord provided with the Model 651 into the power connector (100 to 240 VAC 50/60 Hz 175 W) on the back panel.

2.Plug the cord into an earth-grounded AC power source (100 to 240 VAC, 50 to 60 Hz, 175 W).

07506C DCN6727

31

Page 33
Image 33
Teledyne 651 operation manual Connecting the USB Cable, Connecting Power and Warming up the Model