Thermador SEC271 manual Interpreting the Control Panel Sights & Sounds, Volt Connection

Oven Features Built-in Oven Care and Use Manual

Interpreting the Control Panel: Sights & Sounds

The directions in the Care and Use Manual for setting the oven and its various modes are based on the assumption that the control panel displays and sounds will lead you through the process. To assist you further, the following descriptions will help you interpret what is seen and heard.

Flashing Symbols or Numbers

Signals an incomplete setting; calls for another step or START to be touched.

1 Beep

Door Lock Indicator

Displays during the Self-clean mode whenever the door is locked. Door can be opened when symbol no longer appears.

Signals the receipt of an entry.	Err
2 Short Beeps	Displays if an invalid temperature or time is entered.

Signal an error in entry.

4 Long Beeps

Signal the end of a setting.

Volume

The volume of the beeps can be adjusted. Touch and hold the START pad and the PROBE pad for three seconds. Touch PROBE pad again to increase or decrease volume, from levels 1 to 3. Touch START to set volume selection.

Active Oven Symbol

This symbol indicates which mode is being displayed.

Probe Symbol

Displays the internal temperature of the meat rather than the oven roasting temperature. Oven tempera- ture can be seen briefly by touching the cook mode after touching START.

Power Failure

After the power returns to the oven, the clock dis- plays the time when the power was lost or turned off.

F Number Codes

These codes are displayed when there is a problem with the signal sent to the electronic control board. See Solving Operational Problems, Page 34.

Convection Fan

Operates during any convection mode. The fan turns off if the door is opened. The convection fan will also run during the preheat time.

Component Cooling Fan

Activates during any cooking or self-cleaning mode to cool inner components and outer door surfaces. This air is exhausted through the vent located below the lower oven in double oven models. It continues to run until components have cooled sufficiently.

Single oven model control panel

shown in 20º open position.

TOUCH 'n' TILT PANEL

This panel is on 30"single C oven models only. It can be used in the tilt or flush-to-oven position. Push in along the center bottom of the panel to release latch and raise panel upward. Push again to release latch and lower the panel.

208 VOLT CONNECTION

•Preheat time will be slightly longer.

•Broil time will be slightly longer.

•The Self-Clean mode may need a longer clean time than normal, depending on the amount of soil.

6