Westell Technologies 327W manual Check Public LAN Dhcp Settings

User Guide VersaLink™ Gateway (Model 327W)

If you clicked the Public LAN Enable box, the following screen will be displayed, showing the Public LAN Enable box selected. Click on save.

If you selected Public LAN Enable, or if you made other changes in the Public LAN Configuration screen and clicked save, the following pop-up screen will be displayed. Click OK to save the new settings. If you click on Cancel, your new settings will not take effect.

NOTE: DHCP Lease Time value must be greater than 10 seconds. The default = 01:00:00:00. Seconds must be between 0 and 59, minutes must be between 0 and 59, and hours must be between 0 and 23.

If the settings you have entered in the Public LAN Configuration screen are incorrect, the following warnings messages may be displayed via pop-up screens. If this occurs, check settings in the Public LAN Configuration screen.

Warning Message		Check Public LAN DHCP Settings
Start Address is not part of the Subnet		Check the value in the DHCP Start Address field
End Address is not part of the Subnet		Check the value in the DHCP End Address field
End Address is below the Start Address		Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds		Check the values in the DHCP Lease Time fields
030-300500 Rev. A	81	October 2006