User Guide | VersaLink™ Gateway (Model 327W) |
12.5.2 DHCP Configuration (Private LAN)
The following settings will be displayed if you select DHCP from the Advanced LAN menu.
| DHCP Server | This setting allows VersaLink to automatically assign IP addresses to local devices |
| |
|
| connected on the LAN. Westell advises setting this to enabled for the private LAN. |
| |
|
| Off = DHCP Server is disabled |
|
|
|
| Private LAN = DHCP addresses will be saved into the Private LAN configuration. |
| |
|
| Public LAN = DHCP addresses will be saved into the Public LAN configuration. |
| |
|
| This option is only available if the Public LAN DHCP server is enabled. |
|
|
|
| NOTE: These addresses will be overwritten if the Internet Service Provider |
|
|
|
| supports dynamic setting of these values. |
|
|
| DHCP Start Address | Factory Default = 192.168.1.15 |
|
|
|
| This field displays the first IP address that the DHCP server will provide. The |
| |
|
| DHCP Start Address must be within the IP address and lower than the DHCP End |
| |
|
| Address. You may use any number from 0 to 254 in this address. |
|
|
| DHCP End Address | Factory Default = 192.168.1.47 |
|
|
|
| This field displays the last IP address that the DHCP server will provide. The |
| |
|
| DHCP End Address must be within the IP address and higher than the DHCP Start |
| |
|
| Address. You may use any number from 0 to 254 in this address. |
|
|
| DHCP Lease Time | Factory Default = 01:00:00:00 |
|
|
|
| Displays the amount of time the provided addresses will be valid, after which the |
| |
|
| DHCP client will usually |
|
|
|
| NOTE: DHCP Lease Time value must be greater than 10 seconds. Seconds must |
| |
|
| be between 0 and 59, minutes must be between 0 and 59, and hours must be |
|
|
|
| between 0 and 23. |
|
|
|
|
|
|
|
| 72 | October 2006 | ||
