Installing Software

There are four drivers provided:

-PCL5

-PostScript

-Twain

-ControlCentre

The installation procedure is the same for all of them. You can install all of the drivers at the same time or as many as you require.

#These instructions are for installing direct printing and scanning via the parallel or USB. For Xerox WorkCentre M20i network connections, it is recommended that you contact your System Administrator or refer to the System Administration Guide.

Getting Started

The Xerox WorkCentre M20 and M20i can be connected directly to the USB or Parallel Port of a host Workstation. A document file can be sent or received from the host Workstation via the appropriate port to the Xerox WorkCentre M20 or M20i.

Prior to installing the drivers, ensure the USB or Parallel Port connection has been made between the Xerox WorkCentre M20 or M20i and the Workstation.

#2For-12.USB or Parallel Port connection instructions, refer to “Making Connections” starting on page

There are three stages required to installing the machine on a port on a local workstation:

!Install the driver.

This requires the appropriate printer driver to be installed on the workstation.

!Workstation Setup

This requires the workstation to be configured to print to the WorkCentre M20i.

!Test Print or Scan

A print job should be submitted to ensure the WorkCentre M20i has been installed and configured correctly.

Xerox CopyCentre C20, WorkCentre M20 and WorkCentre M20i User Guide

Page 2-23

Page 47
Image 47
Xerox M20/M20i manual Installing Software, Workstation Setup, Test Print or Scan