3Com CS/2500 manual Changing, Procedure, Following menu is displayed

Changing the Configuration 4-3

Changing the	To change the communications server configuration, follow this
Configuration	procedure:
	1 Enter the firmware configuration command fc at the monitor prompt.
	The following menu is displayed:

Firmware Configuration Utility

Commands:

C- Change parameters

D- Display parameters es - Exit to monitor

c

2Type D to display current parameter settings.

The following display shows factory default settings for the CS/2600 (except for Ethernet address, which is only an example):

			Current	Parameters:
Ethernet address				080002025DAC
Console		baud	rate	9600
Console		port		0
Continuous self-test				Disabled
Auto-reboot				Reboot only
Monitor				Disabled
Initial		boot	source	Floppy then	Network
Number		of reboots		00
Network		boot	string	_cs200
Boot	retries			Try Forever
Boot	protocol			SLP
Number		of ports		10
Default		memory map		CS/2500/2600
RS-232		ports		0 1 2 3 4 5	6 7 8 9
RS-422		ports
Auto RS-422 select				Disabled
LF issued after CR				YES
Printer		setup	string:

Default settngs for the CS/2500 are the same, except that Initial Boot

Source is “Network.”

3To return to the Firmware Configuration Utility menu, press the Return key.