B

STARTUP MESSAGES

At power-on or reset, the server performs self-tests and diagnostics. When a console is attached and monitor mode is enabled, it sends status and error messages generated by these tests to the console, if possible. This appendix lists these messages in alphabetical order.

The server may not always be able to report a failure on the console (for example, CPU failure).

If you receive an error message, refer to Chapter 6, “Troubleshooting.” If you still receive an error message, contact 3Com or your network supplier. Refer to Appendix D, “Technical Support,” for technical support information.

3Com Series/2000 Monitor

Meaning: The server is in monitor mode.

CPU - Failed Test # x

Meaning: An error was encountered in CPU test x.

CPU - Passed C3 MMON rev. <xxx>

Meaning: No errors were encountered in CPU self-tests. The server’s firmware revision is <xxx>.

EC - Failed Test # <x>

Meaning: An error was encountered in Ethernet controller test <x>.

EC - Passed Station Address - <xxxxxxxxxxxx>

Meaning: No errors were encountered in Ethernet controller tests. The server’s Ethernet address is <xxxxxxxxxxxx>.

Series/2000 Power-up

Meaning: Self-tests have begun.

Page 95
Image 95
3Com CS/2500 manual Startup Messages