5-12 CHAPTER 5: MAINTENANCE AND UPGRADES
| 1 | Remove |
|
| |
|
| connector from |
|
| |
| Rear | motherboard. |
|
| |
|
|
|
| ||
| Power supply |
|
| ||
| WARNING: |
|
| ||
| Hazardous voltage. |
|
| ||
| Do not open. | 3 | Remove | ||
Motherboard | No | ||||
| screw. | ||||
| parts inside. |
| |||
|
|
| |||
|
|
| 4 | Pull out power | |
|
|
|
| supply. | |
|
|
| 5 Remove | ||
|
|
|
| power wiring | |
|
|
|
| harness connector. | |
| 2 | Disconnect cable and |
|
| |
|
| pull taut to expose screw. | |||
|
| Daughtercard |
|
| |
| Front |
|
|
| |
Figure 5-7 Removing the Power Supply
4Install the new power supply module.
a For Model CS/2600 only, reconnect the power wiring harness to the connector on the rear of the diskette drive.
b For both models, slip the keyhole slots on the bottom of the power supply module over the standoffs on the bottom of the chassis. Slide the power supply module toward the rear of the chassis.
c Fasten the module in place with the screw.
5For Model CS/2600 only, reconnect the cable from the diskette drive to the daughtercard.
6Reconnect the power supply cable bundle to the connector on the motherboard.
Make sure you keep the connector keys aligned.
7Replace the cover, as described in “Replacing the Cover” on page
