186

AT-TQ2403 - Management Software - User's Guide

 

 

∙Reset the access point from its Administration UI. To do this, go to http://IPAddressOfAccessPoint, navigate to Reset Configuration, and click the Reset button. (IP addresses for APs are on the Cluster > Access Points page for any cluster member.)

∙Physically reset the access point by pressing the Reset button on the device.

BootLoader Recovery

If you power off the AP during the firmware upgrading process, the AP may no longer boot. To start bootloader firmware recovery, perform the following steps:

Step 1 : Download the newest firmware and rename the file as "TQ2403_upgrade.img"

Step 2 : Power off the AP

Step 3 : Connect the PC with the AP via Ethernet port.

Step 4 : Set the IP of the PC to 192.168.1.1. Make sure there is no device configured with IP address equal to 192.168.1.230 in the network.

Step 5 : Run TFTP server on the PC and save the file "TQ2403_upgrade.img" to TFTP server directory.

Step 6 : Power on the AP.

The firmware recovery process will start. Please wait about 5 minutes and the AP will boot up again.