220

AT-TQ2403 - Management Software - User's Guide

 

 

2.Turn off Dynamic DNS Nameservers and re-check the settings:

AT-TQ2403# set host dns-via-dhcp down AT-TQ2403# get host dns-via-dhcp down

3.Get the current IP addresses for the DNS Nameservers:

AT-TQ2403# get host static-dns-1 10.10.3.9

AT-TQ2403# get host static-dns-2 10.10.3.11

4.Re-set the IP addresses for the DNS Nameservers as desired:

AT-TQ2403# set host static-dns-1 10.10.3.10 AT-TQ2403# get host static-dns-1 10.10.3.10

AT-TQ2403# set host static-dns-2 10.10.3.12 AT-TQ2403# get host static-dns-2 10.10.3.12

Set DNS Nameservers to Use DHCP IP Addressing (Manual to Dynamic Mode)

To switch DNS Nameservers from Manual (static IP addresses) to Dynamic mode (nameserver addresses assigned by DHCP), use the reverse command and check to see the new configuration:

AT-TQ2403# set host dns-via-dhcp up AT-TQ2403# get host dns-via-dhcp up

Wireless Interface

To set up a wireless (radio) interface, configure the following on each interface (Internal or Guest) as described in other sections of this CLI document.

∙Configure the Radio Mode and Radio Channel as described in “Configure Radio Settings”.

∙Configure the Network Name as described in “Set the Wireless Network Name (SSID)”.

Guest Access

The following sections explain how to get current status of the relevant settings, enable Guest Access, and set up guest networks using VLAN solution:

∙Find out if Guest Access is Enabled

∙Enable or Disable Guest Access

∙Find out if Guest Access is set up on a VLAN

∙Enable / Configure Guest Access on VLANs