AT-TQ2403 Management Software User's Guide

65

 

 

For a minimum level of protection on a guest network, you can choose to suppress (prohibit) the broadcast of the SSID (network name) to discourage client stations from automatically discovering your access point. (See also “Does Prohibiting the Broadcast SSID Enhance Security?”).

For more about the Guest network, see “Setting up Guest Access”.

Static WEP

Wired Equivalent Privacy (WEP) is a data encryption protocol for 802.11 wireless networks. All wireless stations and access points on the network are configured with a static 64-bit(40-bit secret key + 24-bit initialization vector (IV)), 128-bit(104-bit secret key + 24-bit IV), or 152-bit(128-bit secret key + 24-bit IV) Shared Key for data encryption.

You cannot mix 64-bit, 128-bit, and 152-bit WEP keys between the access point and its client stations.

Static WEP is not the most secure mode available, but it offers more protection than setting the security mode to None (Plain-text)as it does prevent an outsider from easily sniffing out unencrypted wireless traffic. (For more secure modes, see the sections on “IEEE 802.1x”, “WPA Enterprise”, or “WPA Personal”.)

WEP encrypts data moving across the wireless network based on a static key. (The encryption algorithm is a "stream" cipher called RC4.)

The access point uses a key to transmit data to the client stations. Each client station must use that same key to decrypt data it receives from the access point.

Client stations can use different keys to transmit data to the access point. (Or they can all use the same key, but this is less secure because it means one station can decrypt the data being sent by another.)

If you selected Static WEP Security Mode, provide the following on the access point settings:

Figure 24: Security Setting Page – Static WEP Setting