248 | |
|
|
Note: To get a list of all properties you can set on the AP radio, type the following at the CLI prompt:
set radio wlan0 [Space] [Tab] [Tab]
1.Turn the Radio On or Off
2.Set the Radio Mode
3.Enable or Disable Super AG
4.Set the Channel Policy
5.Set the Radio Channel
6.Configure Basic and Supported Rate Sets
7.Set the Beacon Interval
8.Set the DTIM Period
9.Set the Fragmentation Threshold
10.Set the RTS Threshold
1.Turn the Radio On or Off
Feature or Setting | CLI Command |
|
|
To turn the radio on: | set radio wlan0 status on |
|
|
To turn the radio off: | set radio wlan0 status off |
|
|
2. Set the Radio Mode
Valid values depend on the capabilities of the radio. Possible values and how you would use the CLI to set each one are shown below. (For information about Atheros Turbo modes see 802.11a Turbo in Glossary.)
Feature or Setting | CLI Command |
|
|
IEEE 802.11b | set radio wlan0 mode b |
|
|
IEEE 802.11g | set radio wlan0 mode g |
|
|
IEEE 802.11a | set radio wlan0 mode a |
|
|
Atheros Turbo 5 GHz | set radio wlan0 mode |
|
|
Atheros Dynamic Turbo 5 GHz | set radio wlan0 mode |
|
|