208

 

AT-TQ2403 - Management Software - User's Guide

 

 

 

 

 

 

 

 

 

Feature or Setting

CLI Command

 

 

 

 

 

 

Enable Remote Logging and Specify the Log

As a prerequisite to remote logging, the Log Relay Host

 

 

 

must be configured first as described in “Setting Up the Log

 

 

Relay Host for the Log

Relay Host”.

 

 

 

See complete explanation of CLI commands at

 

 

 

“Enable Remote Logging and Specify the Log Relay Host

 

 

 

for the Log”

 

 

 

Here are a few:

 

 

 

set log relay-enabled 1 -enables remote logging

 

 

 

set log relay-enabled 1 -disables remote logging

 

 

 

get log

 

 

 

set log -TAB TAB shows properties you can set

 

 

 

on the log

 

 

 

 

 

 

Get Transmit / Receive Statistics

get interface all ip mac ssid tx-packets tx-bytes

 

 

 

tx-errors rx-packets rx-bytes rx-errors

 

 

 

 

 

 

Get Client Associations

get association

 

 

 

 

 

 

Get Neighboring APs

get clustered-ap

 

 

 

 

 

Get Information on the Management Interface for the AP

The following command returns all information on the internal interface for an access point:

AT-TQ2403# get management

 

Property

Value

--------------------------------------------------------------------------------

vlan-id

 

interface

br0

static-ip

192.168.1.230

static-mask

255.255.255.0

ip

192.168.1.230

mask

255.255.255.0

mac

00:01:02:03:02:00

dhcp-status

down

management-ip-enabled

0

management-ip-address

192.168.1.1

deny-wlan-management-enabled

0

deny-wlan-management-ping

0

deny-wlan-management-telnet

0

deny-wlan-management-http

0

deny-wlan-management-snmp

0

deny-wlan-management-tftp

0