198

 

AT-TQ2403 - Management Software - User's Guide

 

 

 

 

 

 

 

 

 

Interface

Description

 

 

brvwnx

The bridge interface for Virtual Wireless Network (VWN) where "x" indicates the

 

 

 

number of the VWN.

 

 

 

 

 

 

wlan0

The wireless (radio) interface for the Internal network.

 

 

 

 

 

 

wlan0guest

The wireless (radio) interface for the Guest network.

 

 

 

 

 

 

wlan0vwnx

The wireless interface for Virtual Wireless Network (VWN) where "x" indicates the

 

 

 

number of the VWN.

 

 

wlan0wdsx

A wireless distribution system (WDS) interface where "x" indicates the number of the

 

 

 

WDS link. (For example, wlan0wds1.)

 

 

wlan1

On a dual radio AP, the wireless (radio) interface for the Internal network on the

 

 

 

second radio.

 

 

wlan1guest

On a dual radio AP, the wireless (radio) interface for the Guest network on the second

 

 

 

radio.

 

 

wlan1vwnx

On a dual radio AP, the wireless interface for Virtual Wireless Network (VWN) where

 

 

 

"x" indicates the number of the VWN.

 

 

vlanxxxx

A VLAN interface for VLAN ID xxxx. To find out what this VLAN interface is (Internal,

 

 

 

Guest, Management), use the following command to look at the "role" property:

 

 

 

get interface vlanVLANID role

 

 

 

For example:

 

 

 

get interface vlan1234 role

 

 

 

 

 

Understanding CLI Validation of Configuration Settings

The CLI performs validation on individual property values in a set or add, but does not check to see if different property values are consistent with each other. For example, it would not provide any error if a radio's mode was set to "a" and its channel was set to "1". (Even though "1" is not a valid channel in "a" mode, it is a valid channel in "g" mode.) In cases where the configuration is left in an inconsistent state, the services associated with the configuration may not be operational. Therefore, it is important to consult the class and property reference to understand the acceptable values for properties given the values of other properties. For more information, see “CLI Classes and Properties Reference”.

Saving Configuration Changes

The AT-TQ2403 Management Software maintains three different configurations.

∙Factory Default Configuration - This configuration consists of the default settings shipped with the access point.

You can always return the AP to the factory defaults by using the factory-resetcommand, as described in “Reset the AP to Factory Defaults”.

∙Startup Configuration - The startup configuration contains the settings with which the AP will use the next time it starts up (for example, upon reboot).

To save configuration updates made from the CLI to the startup configuration, you must execute the save-runningor set config startup running command from the CLI after making changes.