AT-TQ2403 Management Software User's Guide

223

 

 

welcome-screen-text Thank you for using wireless Guest Access as provided by this AT-TQ2403. Upon clicking "Accept", you will gain access to our wireless guest network. This network allows complete access to the Internet but is external to the corporate network. Please note that this network is not configured to provide any level of wireless security.

Enable/Disable the Guest Welcome Page

To enable the Guest welcome page:

AT-TQ2403# set portal status up

To disable the Guest welcome page:

AT-TQ2403# set portal status down

Set Guest Welcome Page Text

To specify the text for the Guest welcome page:

AT-TQ2403# set portal welcome-screen-text "Welcome to the Bewitched Network"

Review Guest Login Settings

The following example shows the results of the "set portal" command after specifying some new settings:

AT-TQ2403# get portal

 

Property

Value

-----------------------------------------------------

status

up

welcome-screen

on

welcome-screen-text

Welcome to the Bewitched Network

Configuring Virtual Wireless Networks (VWNs)

Note: Before configuring this feature, make sure you are familiar with the names of the interfaces as described in “Understanding Interfaces as Presented in the CLI”. The interface name you reference in a command determines whether a setting applies to a wired or wireless interface, the Internal or Guest network, or (on a dual-radio AP) to radio "one" or radio "two".

To configure additional networks on VLANs, you must first enable Virtual Wireless Networks. You can add up to a maximum of 14 VWNs.

Feature or Setting

CLI Command

Find out whether VWNs are enabled

get access-point vwn-status

or not