270

AT-TQ2403 - Management Software - User's Guide

 

 

add

Add an instance to the running configuration

factory-reset

Reset the system to factory defaults

get

Get property values of the running configuration

reboot

Reboot the system

remove

Remove instances in the running configuration

save-running

Save the running configuration

set

Set property values of the running configuration

∙Example 2: Type "get " TAB TAB (including a space after get) to see a list of all property options for the get command.

AT-TQ2403# get

 

access-point

Guest, VLAN and VWN settings

ap-list

AP list for rogue AP detection

association

Associated station

basic-rate

Basic rates of radios

bridge-port

Bridge ports of bridge interfaces

bss

Basic Service Set of radios

channel-planner

Channel planner settings

cluster

Clustering-based configuration settings

config

Configuration settings

detected-ap

Detected access point

dhcp-client

DHCP client settings

dot11

IEEE 802.11 (all radios)

firmware-upgrade

Upgrade firmware of the AP through http

host

Internet host settings

interface

Network interface

ip-route

IP route entry

log

Log settings

log-entry

Log entry

mac-acl

MAC address access list item

management

Management communication configurations

ntp

Network Time Protocol client

portal

Guest captive portal

radio

Radio

radius-user

RADIUS user

serial

Serial access to the command line interface

snmp

SNMP (Simple Network Management Protocol)

ssh

SSH access to the command line interface

static-ip-route

Static IP route entry - used when DHCP is off

supported-rate

Supported rates of radios

system

System settings

telnet

Telnet access to the command line interface

traphost

Destination host for SNMP trap

tx-queue

Transmission queue parameters

untagged-vlan

Untagged VLAN configuration

vwn

Virtual Wireless Network

web-server

Web server

wme-queue

Transmission queue parameters for stations

∙Example 3: Type "get system v" TAB. This will result in completion with the only matching property, "get system version". (Hit ENTER to get the output results of the command.)

AT-TQ2403# get system v

AT-TQ2403# get system version

∙Example 4: Type "set" TAB TAB (including a space after set) to get a list of all property options for the set command.

AT-TQ2403# set