202 |
| |||
|
|
|
|
|
brvwn12 | bridge | down | 00:00:00:00:00:00 |
|
brvwn1 | bridge | down | 00:00:00:00:00:00 |
|
brvwn4 | bridge | down | 00:00:00:00:00:00 |
|
brvwn14 | bridge | down | 00:00:00:00:00:00 |
|
lo | loopback | up | 00:00:00:00:00:00 127.0.0.1 | 255.0.0.0 |
eth0 | ethernet | up | 00:5C:00:1C:00:1C |
|
Get the Firmware Version for the Access Point
In the following example, the access point is running Firmware Version:1.0.0.9. Use the get command as shown to obtain the Firmware Version.
Get the Location of the Access Point
In the following example, the location of the access point has not been set. Use the get command as shown to obtain the location of the access point.
Set the Location for an Access Point
To set the location for an access point, use the set command as follows:
To check to make sure that the location was set properly, use the get command again to find out the location
Vicky’s Office
Get the Current Password
For security reasons, you cannot directly retrieve the password of a device. If you forget the password of a device, and you have a CLI session, you can change the password to a new value. Alternatively, you can perform a factory reset to return the default password.
Although you cannot directly retrieve a password, you can retrieve an encrypted copy of it. This is useful if you want to set the same password on several different devices. In that case, you can get the encrypted password on one device, copy that value, and set the encrypted password to be the same value on other devices.
Note: If the devices are clustered, this happens in the background when you change the password. All passwords on the clustered devices will be the same.
Set the Password