AT-TQ2403 Management Software User's Guide

211

 

 

static-channel

36

channel

36

Property

Value

---------------------------------------------------------------------------------

tx-power

100

tx-rx-status

up

beacon-interval

100

rts-threshold

2347

fragmentation-threshold

2346

super-ag

no

atheros-xr

no

load-balance-disassociation-utilization

0

load-balance-disassociation-stations

0

load-balance-no-association-utilization 0

ap-detection

off

station-isolation

off

frequency

5180

wme

off

rate-limit-enable

off

rate-limit

50

rate-limit-burst

75

Get Status on Events

AT-TQ2403# get log-entry

 

 

number priority time

daemon

message

------------------------------------------------------------------------------------------------------

1

info

Jan

1 00:04:51

login[289]

root login on `ttyS0'

2

notice

Jan

1 00:02:07

syslog

Device boot up

3

info

Jan

1 00:02:06

dropbear[277]

Not forking

Get Status on Persistence

If Persistence is enabled, all logs become persistent and are written to NVRAM and after a reboot, all logs are recoverable from your system. Non-persistent logs are only kept during the run-time period. Therefore, if Persistence is disabled and you reboot the access point, all non-persistent logs will be lost. To determine the status of Persistence, use the following CLI command:

AT-TQ2403# get log persistence no

Enable or Disable Persistence

In the above example Persistence is disabled. Suppose you want to enable Persistence to ensure that logs are written to NVRAM. Use the following command to enable Persistence:

AT-TQ2403# set log persistence on

Alternatively, if you wanted to disable Persistence, use the following CLI command:

AT-TQ2403# set log persistence off

Specify the Severity of Messages to be Displayed in the Event Log

The purpose of severity configuration is to filter or limit the security messages that are displayed in the Event log. It is unlikely that you will want to see a list of all messages. Those of less severity or significance can be filtered using the Severity Configuration feature.