5.Select “Binary Transfers” from the Settings pull down menu within Terminal program.

6.Set the Binary Transfer protocol to XModem/CRC.

7.Close menu and save the settings.

8.Terminal Communications settings are now complete.

Windows 95

1.Power up the Host and start Windows software.

2.In “Control Panel” select and open “System”.

3.Open “Ports”, select the COM port you are using then click “properties”.

Figure 5-2

4.Be sure the port settings are as: Bits per second=9600, Data bits=8, Parity=none, Stop bits=1 and Flow control=Xon/Xoff.

Windows NT

1.Power up the Host and start Windows software.

2.In “Control Panel”, select and open “Ports” then click “Settings”.

Figure 5-3

3.Be sure the port settings are as: Bits per second=9600, Data bits=8, Parity=none, Stop bits=1 and Flow control=Xon/Xoff.

5-2 Operation

MN1851

Page 37
Image 37
Baldor MN1851 manual Windows NT