Baldor MN1851 manual Components not provided with Control, Baldor Control

Figure 3-5 Single Phase AC Power Connections (LP1AxxT & LP2AxxT only)

	L1	L2	L1	L2
		Earth
Note 1	* Circuit	Note 3 & 4	Alternate *
			Fuse	Note 1
	Breaker
			Connection
Note 2

				* Components not provided with Control.
	L	N
			Notes:
		Baldor
			1.	See “Protection Devices” described in this section.
		Control	2.	Metal conduit or shielded cable should be used. Connect
				conduits so the use of a Reactor or RC Device does not
				interrupt EMI/RFI shielding.
			3.	Use same gauge wire for Earth ground as is used for L and N.
				(VDE (Germany) requires 10mm2 minimum, 6AWG). For CE
For CE Compliance, refer to Section 8 of this manual.				Compliance, connect	to the backplane of the enclosure.
			4.	Reference EMC wiring in Section 8.

Figure 3-6 Single Phase AC Power Connections (LP1AxxS only)

	L1	L2	L1	L2
		Earth
Note 1	* Circuit	Note 3 & 4	Alternate *
			Fuse
	Breaker
			Connection
Note 2

Note 1

L1 L2 L3 PE

Baldor

Control

For CE Compliance, refer to Section 8 of this manual.

*Components not provided with Control.

Notes:

1.See “Protection Devices” described in this section.

2.Metal conduit or shielded cable should be used. Connect conduits so the use of a Reactor or RC Device does not interrupt EMI/RFI shielding.

3.Use same gauge wire for Earth ground as is used for L and N.

(VDE (Germany) requires 10mm2 minimum, 6AWG). For CE

Compliance, connect to the backplane of the enclosure.

4.Reference EMC wiring in Section 8.

Note: These Lin+Drive versions are not designed for use with 400/460VAC connections.

3-6 Receiving & Installation MN1851