Baldor manual Methods, Communication Settings Parameter, Variable, MN1851 Command Set B-9

X1 Possible Faults – Continued

X1 Fault	Display	Description
12	“FAULT_RELAY”	when fault relay is closed. Displays ’9’.
13	“EAF”	N.I
14	“MISSING INT”	N.I
15	“POWER_ID”	DRV.ID != SYS.POWER. Displays small ’u’.
16	“CW_CCW”	Both limit switches are on. Displays ’L’.
17	“DESIGN_FAILURE”	Control design fail. Displays small ’c’.
18	“EE_CLEARED”	EEPROM header stamp was not detected.
		Displays big ’U’
19	“EE_INTEGRITY”	EEPROM footer stamp was not detected. Displays big ’A’.
20	“EAF Drive Temp”	EAF drive over temperature error. Displays ’6’.
21	“EAF Motor Temp”	EAF motor over temperature error. Displays ’6’.
22	“EAF Drive I2T”	EAF drive I2T error. Displays ’6’.
23	“EAF Motor I2T”	EAF motor I2T error. Displays ’6’.

Methods:

Command	Description	Parameter	Units	Range
FRST	Resets system faults if allowed. Reset is not allowed, if	–	–	–
	error is still pending.
LOGRST	Resets system fault log	–	–	–

Communication Settings

Parameter:

Command	Description	Units	Range	Default	E2 / Par. set
ECHO	Disable / enable echoing for input	–	“ON/OFF	“ON”	– / –
	characters
PROMPT	Enables / disables terminal prompt	–	“ON/OFF	“ON”	– / –
TALK	Enables / Disables terminal error	–	“ON/OFF	“ON”	– / –
	notification

Variable:

Command	Description	Units	Range	Default	E2 / Par. set
COM.STTS	Queries the most recent communication	–	0:65535		– / –
	handler error

Methods:

Command	Description	Parameter	Units	Range
B	Opens communication to the drive, called by its address	Address	–	0 : 7
	(the addresses a constant, which can be queried by
	COM.ADDR or SYS.STTS)

MN1851 Command Set B-9