Bay Technical Associates none Connecting to a V.34 Modem Interface, Modem Adapter Module Defaults

Installing the BayStack Advanced Remote Node

Connecting to a V.34 Modem Interface

You can connect an RJ-11 telephone cable to any ARN that contains a V.34 modem adapter module.

Note: The default settings for the front-panel V.34 modem adapter module differ from the default settings for the back-panel V.34 modem. Refer to “Connecting to a V.34 Modem Module” earlier in this chapter for information about the V.34 modem adapter and its default settings.

Table 1-2 provides the default settings for the V.34 modem adapter module.

Table 1-2.	V.34 Modem Adapter Module Defaults
Modem Signal/Parameter		Value
Clear To Send (CTS)		On
Data Terminal Ready (DTR)		Depends on the modem type. Set the modem to
		answer incoming calls when DTR is active.
Data Carrier Detect (DCD) or RLSD		On while carrier is present (the ARN uses DCD to
		detect modem connect and disconnect).
Data Set Ready (DSR)		On
Ready to Send (RTS)		Ignore
Synchronous/Asynchronous Mode		Asynchronous
AutoAnswer		Set on n rings with DTR active (n must be greater
		than 0).
Local Character Echo		Off
Supervisory Functions		Off
Baud Rate		28800
Data Bits		8
Stop Bits		1
Parity		None

114200 Rev. A 1-19