Canon Vb-C50fi Set Up the Camera, Using a Tripod, aWARNING, Install the camera securely

1. Set Up the Camera

Firstly, set up the camera. Read the following carefully and make sure the camera is set up properly.

Installing the VB-C50Fi

Attach a mounting arm (not included) to the ceiling or a

wall and firmly attach the camera to the arm.

aWARNING:

Install the camera securely.

●When installing the VB-C50Fi on the ceiling or a wall, contact your Canon dealer.

●When installing the VB-C50Fi on the ceiling or a wall, check that it is strong enough to bear the weight of the VB-C50Fi including the mounting arm. Installation in a weak location could result in the VB-C50Fi falling and causing serious injury.

●At least once a year, check for looseness in the camera installation mount. (If the optional wide converter is used, check the converter mount also).

	The MAC address required when making network settings is shown on the rear of the
Note	VB-C50Fi (→ P.1-9). Please make a note of it before installing this unit (→ P.2-8).

Using a Tripod

The screw for mounting a tripod is on the bottom of the VB-C50Fi.

● Do not overtighten the mounting screw.

If excessive force is used to tighten the mounting

Note

screw, it may result in camera malfunction.

●Always use a tripod mounting screw that is less than 6.0 mm (1/4 in.) in length. The use of screws 6.0 mm (1/4 in.) long or longer could damage the camera. Also, the tripod seat used should be at least 30 mm (1 3/16 in.) in diameter.

30mm (1 3/16 in.) or wider

Less than 6.0 mm (1/4 in.)

Mounting screw

2-4