Canon Vb-C50fi user manual Click to select, Tip

3. Perform Initial Settings for the Camera

3.The camera connected to the network is automatically detected and its MAC

address, IP address and model name
are displayed.	Click to select

The factory default setting is:

IP address : 192.168.100.1

The MAC address can be found on the warranty card or on the white label attached on the rear of the unit.

Note that VBSetup.exe cannot be used across subnets.

Click the MAC address to select it, and click the “Initial Setup” button.

4.Enter the user name “root” and the factory default password “VB-C50i” and enter the IP address and subnet mask.

If you want to specify a default gateway address, enable the “Set the default route to Ethernet” check box and then enter the default gateway address.

Although the time zone and video signal can also be specified here, there is basically no need to change the time zone setting.

Once you have entered your settings, click the “OK” button.

Tip

● The password for the VB-C50Fi is “VB-C50i”.

● The MAC address for this unit is shown on the rear of the VB-C50Fi (→ P.1-9).

●The IP address 192.168.100.1 is used as the factory default setting. Please set an IP address that suits the environment in which the VB-C50Fi is to be used.

2-8