Cisco Systems OL-15491-01 appendix Ip csg psd

Appendix A CSG2 Command Reference

ip csg psd

ip csg psd

To configure a Cisco Persistent Storage Device (PSD), use the ip csg psd command in global configuration mode. To remove the PSD, use the no form of this command.

ip csg psd [vrf vrf-name]ip-address port-number

no ip csg psd [vrf vrf-name]ip-address port-number

Syntax Description	vrf vrf-name	(Optional) Virtual Routing and Forwarding (VRF) table which the CSG2 is
		to use to communicate with the PSD.
	ip-address	IP address for packets destined for the PSD.
		The CSG2 differentiates PSDs on the basis of their IP addresses. When you
		configure a PSD, make sure that its IP address matches on both the active
		CSG2 and the standby CSG2.
	port-number	Port number for packets destined for the PSD.
		The CSG2 differentiates PSDs on the basis of their port numbers. When you
		configure a PSD, make sure that its port number matches on both the active
		CSG2 and the standby CSG2.
Defaults	No PSDs are configured.
	If no VRF table is specified, the CSG2 uses the global routing table to communicate with the PSD.
Command Modes	Global configuration

Command History

Usage Guidelines

Examples

Release Modification

12.4(11)MD This command was migrated from CSG1.

Changes from CSG1:

•The name of this command changed from records-storageto ip csg psd.

•The configuration mode for this command changed from CSG accounting configuration to global configuration.

•The vrf vrf-namekeyword and argument were added.

You must specify the PSD local port using the ip csg psd local-portcommand before you enter the ip csg psd command.

You can configure only one PSD.

The following example configures a PSD with IP address 1.2.3.4 and port number 7777, that uses VRF table PSDVRF to communicate with the CSG2:

	Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
A-86	OL-15491-01