Clover Electronics LCD2088, LCD2084 instruction manual Connection

Stand-alone DVR Instruction Manual

8-4.2. Connection

There are two ways to access the DVR through the DVR Master as follows.

▫With Set Direct setting

-Click the “CONNECT” button on the DVR Master and then the “Connect Dialog menu” as shown in [Fig. 8-8]will be displayed.

-Click the “Set Direct” in the Connect Dialog menu and click the “EDIT” button.

-Enter the IP address (or WAN IP address of the Router) and Port number, which must be the same as DVR has.

-Click the “EDIT” button again and then the connection list will be created in the Name List (up to 20 lists).

-Choose a Site Name in the Name Lists and click the “CONNECT” button in order to access the DVR.

▫With Get Server setting

-Click the “CONNECT” button on the DVR Master and the “Connect Dialog menu” as shown in [Fig. 8-8]will be displayed.

-Click the “Get Server” in the Connect Dialog menu and click the “EDIT” button.

-Enter the IP address, Port number and Site Name, which must be the same as the MNS has (SETUP-click NETWORK-click MNS in the NETWORK menu: Refer to section 7-7.5 MNS on page 122).

-Click the “EDIT” button again and then the connection list will be created in the Name Lists (up to 20 lists).

-Choose a Site Name in the Name Lists and click the “CONNECT” button in order to access the DVR.

▫With Domain setting

-Click the “CONNECT” button on the DVR Master and then the “Connect Dialog menu” as shown in [Fig. 8-8]will be displayed.

-Click the “Domain” in the Connect Dialog menu and click the “EDIT” button.

-Type the DOMAIN name, Port number and User’s defined name.

-Click the “EDIT” button again and then the Domain list will be created in the Name Lists (up to 20 lists).

142