Chapter 2 Set the Top-of-Form
Set the Top-of-Form
When paper is loaded into the printer, it must be told where you want the top of your form to be. This procedure must be performed the first time paper is introduced into the printer, as well as every time new paper is loaded.
Procedure
1.Be sure the forms thickness lever is lowered. If the printer is off, set the power switch to I (On).
2.Press ON LINE to place the printer in offline mode. The LCD will then display “OFFLINE / CONFIG. CONTROL.”
3.Press FF several times to ensure the paper feeds properly beyond the tractors and over the lower paper path. Ensure the paper folds properly in the stacking area.
2
1
4.Raise the forms thickness lever (1) as far as it will go. This allows you to turn the vertical position knob (2) freely in order to align the
38
