Dell 690 manual Data error See Drive Problems

Alert! Power Supply Fan Failure —

Alert! Previous Fan Failures —

Alert! Previous Thermal Failure —

Alert! Previous Shutdown Due to Thermal Event — Ensure that nothing is blocking the airflow vents and that all the fans are properly installed and operating correctly. Also, ensure that the processor heat-sink assembly is properly installed.

Alert! Previous Reboot Was Due to Voltage Regulator Failure — Contact Dell for assistance. See Contacting Dell.

Alert! System Battery Voltage is Low — Replace the battery. See Replacing the Battery.

Alert! Memory Configuration Mismatch. Please enter Setup for Memory Information details. —

Alert! Memory Risers must be installed as a set of four —

Alert! Uncorrectable Memory Error Previously Detected in DIMM_X/Y —

Alert! Operating in single channel debug mode. Please populate memory in matched sets for normal operation. —

Alert! Memory Built-in Self Test fails in DIMM_X/Y — See Memory Problems.

Alert! Invalid Memory installed. DIMMs must have Full DIMM Heat Spreaders — Ensure that you are using or have installed the full- length heat spreaders correctly.

Attachment failed to respond — See Drive Problems.

Bad command or file name — Ensure that you spelled the command correctly, put spaces in the proper place, and used the correct path name.

Bad error-correction code (ECC) on disk read — See Drive Problems.

Controller has failed — See Drive Problems.

Data error — See Drive Problems.

Decreasing available memory — See Lockups and Software Problems.

Diskette drive 0 seek failure — See Drive Problems.

Diskette read failure — See Drive Problems.

Diskette subsystem reset failed — Run the Dell Diagnostics. See Dell Diagnostics.

Diskette write protected — Slide the write-protect notch to the open position.