
7.Press <Enter> to select the device.
For example, if you are booting to a USB memory key, highlight USB Device and press <Enter>.
NOTE: To boot to a USB device, the device must be bootable. To make sure your device is bootable, check the device documentation.
Changing Boot Sequence for Future Boots
1.Enter system setup (see Entering System Setup).
2.Use the arrow keys to highlight the Boot Sequence menu option and press <Enter> to access the menu.
NOTE: Write down your current boot sequence in case you want to restore it.
3.Press the up- and
4.Press the spacebar to enable or disable a device.
5.Press <U> and <D> to move a selected device up or down the list.
Booting to a USB Device
NOTE: To boot to a USB device, the device must be bootable. To ensure that your device is bootable, check the device documentation.
Memory Key
1.Insert the memory key into a USB port and restart the computer.
2.When F12 = Boot Menu appears in the
The BIOS detects the device and adds the USB device option to the boot menu.
3.See Selecting the Boot Device for the Current Boot.
Floppy Drive
1.In system setup, set the Diskette Drive option to USB.
2.Save your changes and exit system setup.
3.Connect the USB floppy drive, insert bootable media, and
4.See Selecting the Boot Device for the Current Boot.
Clearing Forgotten Passwords
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: This process erases both the system and setup passwords.
1. Follow the procedures in Before You Begin.
CAUTION: Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before attempting to lift, move, or tilt your computer; it requires a
CAUTION: The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the computer tipping over, potentially resulting in bodily injury or damage to the computer.