
c.If the connector has a release tab, press the release tab as you grasp the card by its top corners, and ease it out of its connector.
6.If you are removing the card permanently, install a filler bracket in the empty
NOTE: Installing filler brackets over empty
7. Before you rotate the card retainer back into place, ensure that:
•The tops of all cards and filler brackets are flush with the alignment bar.
•The notch in the top of each card or filler bracket fits around the alignment guide.
NOTE: For extra security, remove the alignment guide (an
1card retainer
2alignment bar alignment guide
3
NOTE: For extra security, remove the alignment guide (an
4 filler bracket
NOTICE: Do not route card cables behind the cards. Cables routed behind the cards could cause damage to the equipment.
8.Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
9.Rotate the card retainer back into its original position; push its tip so that its tab clicks into place.