1Media Card Reader

2screws (4)

7.If an empty 3.5-inch drive carrier is installed in the drive bay, slide the Media Card Reader into the drive carrier until it clicks into place. Otherwise:

a.Slide the Media Card Reader into the 3.5-inch drive carrier until it clicks into place.

b.Then, while pressing down the release lever on the side of the drive carrier, slide the drive carrier into the drive bay until it clicks into place.

1Media Card Reader

2floppy drive/ Media Card Reader carrier

8.Attach the interface cable to the Media Card Reader.

9.Connect the other end of the interface cable to the system board connector labeled "USB." To locate the system board connector, see System Board Components.

Page 72
Image 72
Dell 690 manual