Paper handling
Paper does not feed properly from the sheet feeder.
Cause What to do
Too many sheets are loaded
in the sheet feeder. Take the paper stack out of the feeder,
remove some sheets, and reload the
stack. Before you load paper, check the
amount of paper you can load in the
sheet feeder. See Chapter 6.
The edge guides are not set
correctly. Adjust the guides against the stack of
paper. See “Loading Paper” in
Chapter 3.
Paper is jammed in the paper
path. Press the
E load/eject button. The
printer loads the jammed paper and
then resumes printing. If the error is
not cleared, open the printer cover an d
remove the jammed paper, then reload
paper in the sheet feeder, and press the
E load/eject button. The printer
resumes printing.
The paper stack does not fit
under the edge guide tab
inside the left edge guide.
Reload the paper so that it fits under
the edge guide tab. See “Loading
Paper” in Chapter 3.
The paper is curled or folded. Use flat, undamaged paper.
The paper is old or creased. Use only new, smooth sheets of paper.
The paper’s size is not
compatible with the printer. Use paper that meets the paper
requirements for this printer. See
“Paper” in Appendix C.
LEaster10 Ref. Guide
Rev.C
A5 size Chapter 9
1-07-98 DR, pass 2
9-16 Troubleshooting