DMA transfer
Using DMA transfer to send print data to the computer may
help you speed up printing. This is only available for
computers that have a parallel port which supports ECP mode.
See your computer’s manual to determine if it supports ECP
mode and DMA transfer.
To make DMA transfer available, see below.
1. If a message appears on the Speed & Progress dialog box,
compare it with the table below.
Message Action
High Speed (DMA) Transfer
enabled. DMA transfer is already en abled. Click
OK to close the dialog box.
For higher data transfer rates,
use DMA Transfer. Go to step 4.
<No message>
Your system cannot use DMA transfer.
However if you change the parallel
port setting to ECP or Enhanced using
your computer’s BIOS Setup program,
you may be able to use DMA transfer.
Consult your computer’s manual or
computer maker for instructions.
Note:
Before you run the BIOS Setup
program, uninstall th e printer software.
After running the Setup program,
reinstall the printer software.
2. Double-click the My Computer icon and double-click
Control Panel.
3. Double-click the System icon and click the Device Manager
tab.
4. Double-click the Ports (COM & LPT) icon and double-click
LPT1. If you have connected your printer to a port other
than LPT1, double-click the appropriate port icon.
LEaster10 Ref. Guide
Rev.C
A5 size Chapter 9
1-07-98 DR, pass 2
9-30 Troubleshooting