![](/images/backgrounds/156142/bg38.png)
If you are low on disk space, select Cuso m Install from the
pop-up menu and click Serial Driver Package (if you
connect the printer directly to your Macintosh’s serial port),
or Network Driver Package and Epson Namer (if you
connect the printer to your Macintosh over an AppleTalk
network). Confirm the destination for installation, then
click Install.
For information on the included software, see page 2-28.
Note:
Click the icon to get information on each component.
5. When a message appears informing you that installation
is finished, click Restart to complete the installation and
restart your computer.
If you are going to use the optional LocalTalk Interface Card
(C82312 ) or Type B Ethernet Interface Card (C82357 ), you
need to assign a name to your printer using the EPSON Namer
utility as described below. If you are using a serial interface,
skip to “Using the Chooser to select your printer” on next page.
Assigning a name to the printer Use the following procedure to assign a name:
1. Double-click the Epson Namer icon.
It is located on your hard disk drive if installed. If it is not
installed, insert the printer software CD-ROM into your
computer’s CD-ROM drive and open the utility from there.
(If you use the floppy disk version, insert it in a disk drive
and open the u tility from t here.)
2. Click the SC850(AT) icon in the Device Types window.
Macintosh
2
R
Easter10 Ref. Guide
Rev.C
A5 size Chapter 2
1-07-98 DR, pass 3
Getting Started 2-31