Now you are ready to connect the printer to your computer. To
connect the printer to your PC, see the following sect ion. To
connect it to your Macintosh, see page 2-20.
Connecting the Printer to Your PC Connecting the printer to your computer using the built-in
parallel interface requires a shielded, twisted-pair parallel
cable. To connect the printer to a Macintosh, see page 2-26.
Follow the steps below to connect the printer to your computer:
1. Make sure both the printer and computer are turned off.
2. Plug the cable connector securely into the printer’s interface
connector. Then squeeze the wire clips together until they
lock in place on both sides. If your cable has a ground wire,
connect it to the ground connector below the interface
connector.
3. Plug the other end of the cable into the computer’s parallel
interface. If there is a ground wire at the computer end of
the cable, connect it to the ground connector at the back of
the computer.
e31
LEaster10 Ref. Guide
Rev.C
A5 size Chapter 2
1-07-98 DR, pass 3
2-12 Getting Started