Extron electronic 450 Removing and Installing Button Labels, Making Labels from Paper Templates

Removing and Installing Button Labels

Making Labels from Paper Templates

Figure 110 on page 159 provides strips of blank button labels. If desired, copy them or cut them out, write button information in each button area as desired, and put them in the windows of the input or output buttons.

Installing Labels in the Buttons

Install new labels in the front panel buttons as follows:

1.Remove the button from the matrix switcher; use a small, flat bladed screwdriver such as an Extron Tweeker to gently pry a button out from the front panel (see figure 109).

Clear Lens

Pry the two pieces apart.

Separate the two- piece button here at the corner.

Base

Diffuser

Button Label

Figure 109. Illuminated Button Label Replacement

2.Locate the notch in the corner of one side of the clear button cap lens.

3.Separate the white backing (diffuser) from the clear button cap (lens); insert the blade of the small screwdriver into the corner notch and gently twist the blade.

4.Save the translucent, white diffuser, but remove the text/label insert from the transparent button cap lens.

5.Insert the replacement button label into the button cap. Check for correct label orientation.

6.Align the white diffuser plate with the cap (lens). The bumps on the diffuser plate should be aligned (top and bottom) with the notches on the clear button cap. Firmly snap it into place.

7.Align the tabs on the base of the matrix switcher with the notches on the diffuser plate. Gently, but firmly, press the reassembled button into place in the front panel of the switcher.

8.Repeat steps 1 to 7 as needed to relabel other buttons.

CrossPoint and MAV Series Matrix Switchers • Reference Information 158