Exchanging the Battery | Management Blade |
12.2Exchanging the Battery
In order to save the system information permanently, a lithium battery is installed to provide the CMOS memory with a current. When the charge is too low or the battery is empty, a corresponding error message is provided. The lithium battery must then be replaced.
VCAUTION!
Read the safety information and the information on handling batteries in the section “Batteries” on page 24.
Incorrect replacement of batteries may lead to a risk of explosion. The battery may only be replaced with an identical battery or with a type recommended by the manufacturer.
Make sure you insert the battery the right way round. The plus pole must be at the top!
The following figure shows the position of the battery (1) on the management blade board.
Figure 79: Position of the management blade battery (arrow)
128 | PRIMERGY BX600 S2 Basic Unit |
