Preparation for Use and Operation | Management Blade Configuration |
IThe management blade LAN controller only runs at 10 Mbit/sec. Duplex mode must be defined manually via the Agent NTC Duplex Mode (see figure 21 below).
Figure 21: Agent NIC Duplex Mode menu
ÊEnter 2 if the preset duplex mode value needs to be altered or 0.
IThe transfer rate of 10 Mbit/sec and the duplex mode of the management blade must comply with the client LAN controller! Automatic synchronization is not supported by the management blade LAN controller.
ÊEnter 0 in this menu and in the preceding menus to leave the management blade console menu.
ÊClose the HyperTerminal session.
ÊUnplug the power cable from the basic unit and plug it in again to reboot the management blade.
IThis ensures that the management blade continues to act as the master after the restart. A restart without interruption to the power supply would cause the master/slave assignment to change.
The management blade can now be accessed via the LAN. For more infor- mation on the management blade configuration, see the manual “PRIMERGY BX Blade Server Systems: RemoteView Management Blade - User Interface Description”. Information on the configuration of the various switch blade models can be found in sparate manuals, see “Related Publications” on page 165.
PRIMERGY BX600 S2 Basic Unit | 59 |
