Fujitsu BX600 S2 manual Connecting the System to the Mains, V Caution

Connecting the System to the Mains Installing the Hardware

4.5Connecting the System to the Mains

There are slots for four hot-swappable 2100 W power supply units on the rear of the basic unit. The base system is equipped with two power supply units.

VCAUTION!

●Make sure you observe the information on determining how many power supply units are required (see chapter “Power Supply Concept” on page 139).

●The power supply units switch on automatically at a mains voltage between 200 - 240 V. The base unit may only be commissioned if the local mains voltage is within the voltage range of the system.

●The 2100 W power supply units may only be connected to 16 Amp grounding outlets or CEE outlets. When ordering the base unit, indicate the type of outlet available at the installation site. This will allow us to supply a cable with suitable inlet connectors for non- heating appliances with the order.

2

1

Figure 13: Connecting the basic unit to the mains

ÊFirst connect the insulated connector of the power cables to the power supply units of the basic unit (1), and then plug the power plug (2) into the USV, Power Distribution Unit (PDU) or into an external socket.

VCAUTION!

Always connect the power cable to the power supply units first, and then to the mains.

46 PRIMERGY BX600 S2 Basic Unit