Preparation for Use and Operation Updating BX600 System Components

Figure 26: Transferring the new operation code image file

ÊClick Transfer from Server.

ÊWait a few minutes until the update process is complete. Refresh the browser for viewing.

ÊSelect the new image file in the pop-up window (red arrow) and click Apply Changes.

Figure 27: Selecting Start-Up Operation Code Image File

ÊSelect Reset in the navigation bar.

IAfter resetting, the switch blade will reboot. However, all settings specified previously (IP address etc.) will be lost and must be reentered on the management console.

ÊRepeat the firmware update procedure for each installed switch blade.

PRIMERGY BX600 S2 Basic Unit

67

Page 67
Image 67
Fujitsu BX600 S2 manual Click Transfer from Server