Chapter 9 Operational Settings

Specifying an Area Not to Detect Multifeed

3 Select an operation mode and click the [OK] button.

[Intelligent Multifeed Function]

 

 

 

 

 

 

 

 

Mode

Description

 

 

 

 

 

 

When there is paper of the same size attached to a

 

Manual mode

Stops feeding the documents when a

designated location on the page, the scanner memorizes the

 

 

 

 

multifeed is detected. You can resume

 

 

 

 

scanning by loading the documents back in

location of the attachment and can be configured not to detect

 

 

 

 

the ADF paper chute.

multifeeds for that location. To configure this setting, you first

 

 

 

 

The size and location of the attachment are

need to select [Check Overlapping (Ultrasonic)] or [Check

 

 

 

 

not memorized.

 

 

 

 

 

Overlapping and Length] in either the scanner driver’s setup

 

Auto mode 1

Memorizes the size and location of the

dialog box or the multifeed detection setting in "Method of

 

 

 

 

paper attachment upon resuming the scan

 

 

 

 

when a multifeed is detected and the

Multifeed Detection [Multifeed]" (page 145).

 

 

 

 

 

 

 

 

document is loaded back in the ADF paper

1 Start up the Software Operation Panel.

 

 

 

 

chute. The memorized pattern is ignored

 

 

 

 

from the next scan.

 

 

 

 

 

Refer to "9.1 Starting Up the Software Operation Panel" (page 125).

 

Auto mode 2

Memorizes the size of the paper attachment

 

 

2 From the listing on the left, select [Device Setting 2] J

 

 

 

 

upon resuming the scan when a multifeed is

 

 

 

 

detected and the document is loaded back

[Intelligent Multifeed Function].

 

 

 

 

in the ADF paper chute. The memorized

 

 

 

 

 

pattern is ignored from the next scan.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

z By selecting the [Clear overlap pattern] check box, you

 

 

 

 

can erase the overlapping patterns (length, position)

 

 

 

 

that were memorized in Auto mode.

 

 

 

 

 

 

 

 

z In [Remember multifeed pattern at power-off], you can

 

 

 

 

select whether or not to keep the multifeed pattern

 

 

 

 

upon turning the power off. When [Remember] is

 

 

 

 

selected, you can use eight (pages worth) of the most

 

 

 

 

recent patterns the next time the scanner is powered

 

 

 

 

on.

 

 

 

 

 

 

For details about the procedure after this step, refer to "Ignoring

 

 

Multifeed for a Set Pattern" (page 82).

150