Chapter 4 How to Use the Operator Panel
Indications on Function Number Display |
| Display | Description | ||
|
|
|
|
| |
|
|
| J | Indicates that a temporary error occurred during scanning. | |
Display | Description | ||||
| U | The display will switch between either "J" or "U", and an | |||
|
|
|
| “error number”. | |
8 | Displayed when the scanner has just been powered on. |
|
| ||
|
| For information about the error details, refer to "Temporary | |||
|
|
|
| ||
|
|
|
| ||
P | Processing initialization. |
|
| ||
|
| The display will return to ready ("1") if the [Scan/Stop] or | |||
|
|
|
| ||
0 | Initialization is almost complete. |
|
| [Send to] button is pressed. | |
|
|
| |||
|
|
|
|
| |
|
|
| E | Indicates that a device error (alarm) occurred during | |
1 | Ready to start scanning. |
| |||
| H | initialization or scanning. | |||
| Indicates that the initialization was successfully completed. |
| |||
|
| L | The display will switch between either "E'", "H" or "L", and an | ||
| This state is referred to as "ready". |
| |||
|
|
| “alarm” number. | ||
|
|
|
| ||
Function | A function number will flash after detecting a multifeed. This |
|
| For information about the error details, refer to "Device | |
number | indication prompts whether or not to memorize the overlap |
|
| ||
(flash) | pattern. |
|
| The display will return to ready ("1") if the [Scan/Stop] or | |
| For details, refer to "Ignoring Multifeed for a Set Pattern" |
|
| [Send to] button is pressed. | |
|
|
| When this alarm occurs, turn the power off then back on. | ||
|
|
|
| If the problem still persists, contact your FUJITSU scanner | |
c | Indicates that the ADF was opened when the status was |
|
| ||
|
| dealer or an authorized FUJITSU scanner service provider. | |||
(flash) | ready ("1"). Note that the Check LED will also flash. |
|
|
| |
| None | The display switches off when the scanner enters power | |||
| To return to ready (”1”) status, close the ADF by referring to |
| |||
|
|
| saving mode. | ||
| If the display does not return to ready (“1”) after closing the |
|
|
| |
|
|
|
| ||
| ADF, turn the power off then back on. |
|
|
| |
| If the problem still persists, contact your FUJITSU scanner |
|
|
| |
| dealer or an authorized FUJITSU scanner service provider. |
|
|
| |
|
|
|
|
| |
h | Indicates that the scanner is operating in protection mode. |
|
|
| |
| The scanner may enter this protection mode if it is used for |
|
|
| |
| many hours continuously under high room temperature. |
|
|
| |
| Note that the interval to feed the documents becomes longer |
|
|
| |
| in this mode, but it is not a malfunction. (The recommended |
|
|
| |
| operating environment is 35°C (95°F) or less) |
|
|
| |
| It will return to normal as you just continue scanning. |
|
|
| |
|
|
|
|
| |
50