Chapter 5 Various Ways to Scan

 

 

 

4

Click the [OK] button.

 

 

z Place the end with the black and white pattern as the

 

 

leading edge in the direction of the arrow.

 

D The settings are saved.

 

 

 

 

 

 

z Set the back side of the document (right-hand side of a

5

Scan the document by clicking the [Scan] menu J [Scan]

 

 

 

 

double-page spread) facing towards you.

 

 

z Adjust the side guides to the width of the Carrier Sheet

 

in ScandAll PRO.

 

 

to avoid skewing.

 

D The images on the front and back are merged into a single image.

 

 

 

 

 

 

 

 

 

2 Start up ScandAll PRO and click the [Scan] menu J [Scanner Setting].

DThe [TWAIN Driver (32)] dialog box appears.

If the [TWAIN Driver (32)] dialog box does not appear, check the setting in ScandAll PRO by clicking the [Tool] menu J [Preferences] to open the [Setup] dialog box, then confirm that [TWAIN] is selected for [Device Driver] in the [Scan] tab.

3 Select [Double-page spread] for [Scan Type].

zThere may be a line or a gap appearing between the

！front and back side images. Also when you scan thick papers, images on both left and right may skew towards each other from the top. The degree of these symptoms varies depending on how the document was set or folded. In that case, check the following for possible resolutions:

-Whether the document is folded properly

-Whether the edges of the document are neatly aligned with the edges of the Carrier Sheet

-Turn over the Carrier Sheet to the other (reverse) side and try again

zPart of the image around where the document is folded may appear missing. In that case, set the document so its edge is about 1 mm inside from the edge of the Carrier Sheet.

zWhen [Black & White] is specified for [Image Mode], the edges around the image may appear in black from the shadow of the document.

56