Chapter 9 Operational Settings
9.8 Settings Related to Power ON/OFF
Method of Turning the Scanner ON/OFF | 3 Select one of the following. | |
[Power SW Control] | [Enable power switch | : Press the [Power] button on the |
| ||
| (Factory default)] | operator panel. |
The method by which the scanner is powered ON/OFF can be specified from one of the following:
z Press the [Power] button on the operator panel z Unplug the power cable then plug it back in
z Have the scanner turn ON/OFF in sync with the computer's power
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 125).
2 From the listing on the left, select [Device Setting 2] J [Power SW Control].
[Disable power switch] | : Unplug the power cable then plug it |
| back in. |
[Enable USB power feeding] : Have the scanner turn ON/OFF in sync with the computer's power.
Some types of computers and USB hubs keep supplying
！power to the USB bus even after the computer is turned off.
In that case, the [Enable USB power feeding] mode may not work properly.
152