GE EPM5200P Cause of Last Trip, PRE-TRIP Average Motor, Amps PRE-TRIP U/B Ratio, PRE-TRIP Kwatts

Page	Value	Text Displayed			Description
	2	CAUSE OF LAST TRIP			Message is a brief explanation of trip cause
		message
	3	PRE-TRIP AVERAGE MOTOR
		CURRENT = xxx		AMPS
	4	PRE-TRIP U/B RATIO			Unbalance
		(lI/Ip) xxx	PERCENT
	5	PRE-TRIP G/F CURRENT			Units = *.1 if G/F CT
		G/F=xxx.0	AMPS		ratio = 2000:1
5	6	PRE-TRIP MAX STATOR RTD
		RTD #XX = xxx		C
	7	PRE-TRIP AVERAGE VOLTAGE			Displayed only if MTM unit is installed in 269
		VOLTS = xxx
	8	PRE-TRIP KWATTS			Displayed only if MTM unit is installed in 269
		KW = xxx
	9	PRE-TRIP KVARS			Displayed only if MTM unit is installed in 269
		KVAR = xxx
	10	PRE-TRIP POWER FACTOR			Displayed only if MTM unit is installed in 269
		PF = xxx
	11	PRE-TRIP FREQUENCY			Displayed only if MTM unit is installed in 269
		HZ = xxx
	12	END OF PAGE FIVE			Page footer
		ACTUAL VALUES
	1	PAGE 6: ACTUAL VALUES			Page header
		LEARNED PARAMETERS
	2	LEARNED Istart (AVG OF 4
		STARTS)=xxx AMPS
	3	LEARNED Istart (last one)
		=xxx AMPS
	4	LEARNED K FACTOR
		K = xxx	AMPS
6	5	LEARNED RUNNING COOL
		TIME-xxx	MIN
	6	LEARNED STOPPED COOL
		TIME = xxx MIN
	7	LEARNED ACCEL TIME
		ACCEL TIME = xxx SEC
	8	LEARNED Start Capacity
		Required = xxx		PERCENT
	9	END OF PAGE SIX			Page footer
		ACTUAL VALUES
	1	PAGE 7: ACTUAL VALUES			Page header
		METERING DATA
	2	Vab = xxx	Vbc = xxx		Displayed only if MTM unit is on line
		Vac = xxx	(VOLTS)
		or
		MTM METER MODULE
		NOT INSTALLED
	3	3 PHASE KWATTS			Displayed only if MTM unit is on line
		KW = xxx

90 PMCS Interface Toolkit