Windows Installation
There are different Windows installation methods, depending on the type of cable you connected:
! If you connected a parallel cable, see the section below.
! If you connected a USB cable, see If You Connected a USB Cable. ! If you connected a network cable, see Network Installation.
| If You Connected a Parallel Cable | |
|
| |
Note | The following software installation instructions assume that your | |
| computer was turned OFF when the printer cable was connected. | |
| If your computer was ON, and has not been restarted, the printer | |
| software can still be installed, but the steps will be slightly different than | |
| below. Use the Windows NT 4.0 instructions for your installation. | |
| 1. | Turn your computer on and quit any open programs. |
| ||
| 2. | Follow the steps for your Windows version: |
Windows 3.1x a. Select Main, Control Panel, Printers.
(driver only)
b.In the Printers window, click Add. In the
c.Place the HP LaserJet 2200 CD in the
d.Click Browse. Browse to “D:\English\Drivers\Win3x” (where D is the letter of your
e.Select the HP LaserJet 2200 series driver. Click OK.
f.Close all windows and then restart your computer.
g.To verify that the installation has been completed successfully, open a software application of your choice and open or create a simple document.
h.Make sure the correct printer name appears, and print the document.
i.If the document prints correctly, installation is complete.
If nothing prints or if the document does not print correctly, see the Troubleshooting Checklist.
EN | Chapter 1 Printer Basics 7 |