Note
Note
For best results, use a transparency during this process. If a transparency is not available, use copier grade paper and not bond or rough paper.
During the engine cleaning process, the printer pulls the transparency into the printer and then stops. This is not a jam. The transparency will be slowly stepped through the printer to complete the engine cleaning.
To Start Engine Cleaning
1.Make sure the printer is turned on and in the ready state. Load a transparency in Tray 1.
2.Press and hold the GO and JOB CANCEL buttons until all lights flash. This will take about 10 seconds. Release the buttons when the lights flash.
3.Press the GO button.
4.Discard the blank page produced from the engine cleaning process.
66 Chapter 3 Printer Tips and Maintenance | EN |
