Table B-1. Actions and Warnings

 

Code, Message

Cause

What to Do

 

 

 

W-IS-[31 32 33 34 35] -

The profiler indicated is empty.

Replace the profiler.

[color] Needs Profiler

 

 

 

 

 

W-IS-[41 42 43 44 45] -

The reservoir indicated is empty.

Refill the reservoir.

Refill [color] Reservoir

 

 

 

 

 

W-IS-[51 52 53 54 55] -

A full profiler was installed but the

Remove the full profiler and replace

Full Profiler Should be Removed

ink level is not ready-for-refill.

the previously used profiler.

 

 

W-IS-A - Invalid Cleaning Solvent

Cleaning Solvent profiler is not valid. Replace cleaning solvent profiler.

Profiler

 

 

 

 

 

(LS) Image Sensor

 

 

W-LS-[1 2] Image Sensor Is Not

The image sensor shutter cable is

Connect the image sensor shutter

Operating

disconnected.

cable and restart the printer.

 

 

 

(MD) Media Drive

 

 

A-MD-1 - Media Advance Stalled

The media drive motor has stalled.

Check supply spool for binding, and

 

 

motor for failure.

 

 

 

(MS) Media Sensing

 

 

A-MS-3 - Media Too Far Left/Right

Media is loaded too far to the left or

Reload the media; align right edge to

 

right.

reference mark.

 

 

 

A-MS-4 - Media Out

There is no media loaded.

Load media.

 

 

 

A-MS-5 - Media Too Narrow

Media loaded is not wide enough for

Load media that is at least 24 inches

 

printing.

wide.

W-MS-1 - Media Low

Less than 10 feet (3 meters) of media

 

remains (roll-fed), or less than 1 foot

 

(30 cm) of media remains (sheet-

 

fed).

Monitor printing and reload media to avoid running out of media during printing.

W-MS-2 -

Media loaded may cause head strike. Continue printing or replace media.

Media Non-Standard Width

 

W-MS-4 -

Media Advance Switch on back of

Media Advance Switch Detected

printer was depressed.

Press the Load or Unload button on the control panel to ensure proper tensioning of the supply and takeup.

W-MS-6 -

Media loaded is too wide to be

Replace media. See Appendix A for

Media Too Wide

printed on.

specifications.

 

 

 

(PC) Printing Calibrations

 

 

W-PC-2

- Media Replaced -

Media advance accuracy may need to Run Media Feed Calibration if media

Recalibrate

be recalibrated.

type was changed (page 4-9).

 

 

 

 

W-PC-3

- Head Height Changed -

Change in head height has invali-

Run Fill AutoSet (page 4-7).

Recalibrate

dated calibration.

 

 

 

 

 

W-PC-4

- Jets Not Replaced

Not all missing jets could be

Prime/clean printheads, or choose a

 

 

replaced.

higher quality print mode (page 3-4).

 

 

 

 

W-PC-6

- Uncalibrated Pass Mode

The media advance accuracy is not

Run Media Feed Calibration

 

 

calibrated in the selected mode.

(page 4-9).

 

 

 

 

Diagnostics

B-11

Page 205
Image 205
HP 72SR manual LS Image Sensor